Instructions / Assembly

FILLER STRIP INSTALLATION

If a ller strip is required, measure the distance between the cabinet and the wall and cut the ller

strip to match.

3.2 FILLERS

Fillers are needed to take up odd dimensions when cabinets are installed next to a wall. They will

also allow clearances for doors and drawers to operate properly when turning a corner with a blind

corner cabinet.

Hold the ller in place; turn it over and on the back side make a pencil mark at top and bottom where

it should be cut. To prevent chipping when cutting llers, place masking tape over the surface that

is being cut. Join the two marks with a pencil line and saw along that line. Put the ller in place and

drill a pilot hole at hinge level through the cabinet and into the ller. Attach the ller to the adjacent

cabinet by fastening together with wood screws.

1) When installing a sink or cooktop, trimming may

be necessary to t within the cabinet. Mark cutout

lines where the sink or cooktop will be using the

countertop template that is provided, to ensure

correct measurements. Cut along the marked lines

using a jigsaw.

SINK/COOKTOP INSTALLATION