Instructions / Assembly
6
1) Verify that walls are square and level. Walls that
are out of square or level will make installation
of cabinets more difcult. You can use the 3, 4, 5
method to check your corner.
2) Check the oor for level and
make note of where the highest
points are before installing
cabinets.
4) Using a stud nder, mark out
all of the wall studs that will be
behind your cabinets.
3) Snap a chalk line or draw a level line at 34 1/2" from the
highest point of your oor. Your base cabinets will be adjusted
up to that line (top of base cabinet without countertop). Snap
another chalk line or draw a level line at 54 1/2 (20” above your
base 34 1/2 base cabinet line).
The bottom of your wall
cabinets will be adjusted up to
that line. It may be helpful to
draw out your cabinet layout
on the wall. This will give you a
guide to follow as you go.
If you choose, install a 1x4 or 2x4
ledger board onto the wall at
the bottom of your wall cabinet
height to give a support for the
wall cabinet to set your wall
cabinets on when installing. This
can assist in keeping them level.
This method requires you to
screw into your wall and could
require hole patching.