Installation Guide

7
12)
Set the next cabinet tight to the rst
cabinet and use clamps to hold it place
while you level it and make sure that
the front edges are ush. Attach the two
cabinets together using 1 1/8" particle
board screws. Attach the cabinet to the
wall with 2 1/2" screws into the studs.
Continue with the same process for all
base cabinets.
3.2 FILLERS
A ller is always required against a wall. To cut your ller, measure from the cabinet to the wall
and cut the ller accordingly.
Hold the ller in place; turn it over and on the back side make a pencil mark at the top and
bottom where it should be cut. To prevent chipping when cutting llers, place masking tape over
the surface that is being cut. Join the two marks with a pencil line and saw along that line. Put
the ller in place and drill a pilot hole at hinge-level through the cabinet and into the ller. Attach
the ller to the adjacent cabinet by fastening together with wood screws.
Filler
11) For designs without a corner cabinet,
start with the rst cabinet leaving space
for a ller, as per your plan.