Instructions / Assembly

When installing a sink or cooktop, trimming the top support

rails may be necessary. Using the template supplied by the

sink or cooktop manufacturer, cut the top rails as required

using a jigsaw.

SINK/COOKTOP INSTALLATION

BASE AND BASE BLIND CORNER CABINETS

BBC (base blind corner) cabinets may be pulled out from the corner if required and the room is

available. When installing a base cabinet at a right angle to a BBC cabinet you must use a ller

to provide clearance for door and drawer handles. The ller width required is usually 1 3/4" - 3"

depending on the type of pull used on the cabinets. Cut the 3" ller to required width. Fasten the

ller to the two adjacent cabinets by drilling through the side of the cabinet into the ller. Screw

together. Ensure cabinets are square in corner and attach the unit to the wall. Make sure all

cabinets are plumb and level. The remaining base cabinets are installed in the same manner.

Using the two C-clamps, align stiles, drill and screw together. Proceed around the room making

sure all cabinets are plumb and level, shimming where necessary, then tighten all screws.

• Minimum 42 3/4"

does not allow

for ller/hardware

clearance.

• Maximum

45 3/4" is with

3" ller attached

to be ush with

the door. Filler not

included.

30"

18"

Filler

Trim this

side of

the ller

to make

it t

#8 x 1 1/2"

screws

Install the remaining base cabinets by aligning the front of the cabinet edges. Clamp the

cabinets together and attach using the 1 1/8" screws. Level the cabinet, adjust as required, and

attach to the wall studs using 2 1/2" screws through the hanging rail located at the top of the

base cabinet. After inserting the screws remove the clamps.