SDS

Steel Reinforced Epoxy Hardener - Slow Cure - Twin Tube - Part B
Section 6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Move containers from spill area. Approach release from upwind. Prevent entry into
sewers, water courses, basements or confined areas. Avoid dust generation. Do
not dry sweep. Vacuum dust with equipment fitted with a HEPA filter and place in a
closed, labeled waste container. Dispose of via a licensed waste disposal
contractor. Note: see Section 1 for emergency contact information and Section 13
for waste disposal.
:
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Provide adequate
ventilation. Wear appropriate respirator when ventilation is inadequate. Put on
appropriate personal protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways,
drains and sewers. Inform the relevant authorities if the product has caused
environmental pollution (sewers, waterways, soil or air).
Large spill
:
Move containers from spill area. Avoid dust generation. Using a vacuum with
HEPA filter will reduce dust dispersal. Place spilled material in a designated,
labeled waste container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Methods and materials for containment and cleaning up
For non-emergency
personnel
For emergency responders
:
If specialized clothing is required to deal with the spillage, take note of any
information in Section 8 on suitable and unsuitable materials. See also the
information in "For non-emergency personnel".
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before
eating, drinking and smoking. Remove contaminated clothing and protective
equipment before entering eating areas. See also Section 8 for additional
information on hygiene measures.
Store in accordance with local regulations. Store in original container protected
from direct sunlight in a dry, cool and well-ventilated area, away from incompatible
materials (see Section 10) and food and drink. Keep container tightly closed and
sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabeled containers.
Use appropriate containment to avoid environmental contamination. See Section 10
for incompatible materials before handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Persons with a
history of skin sensitization problems should not be employed in any process in
which this product is used. Do not get in eyes or on skin or clothing. Do not ingest.
Keep in the original container or an approved alternative made from a compatible
material, kept tightly closed when not in use. Empty containers retain product
residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
None.
Section 8. Exposure controls/personal protection
Control parameters
Occupational exposure limits
Biological exposure indices
No exposure indices known.
Date of issue/Date of revision
:
3/22/2024
Date of previous issue
:
3/22/2024
Version
:
2.02
4/10