SDS

Odour threshold
Not Available
Auto-ignition temperature (°C)
Not Available
pH (as supplied)
Not Available
Decomposition
temperature (°C)
Not Available
Melting point / freezing point
(°C)
Not Available
Viscosity (cSt)
Not Available
Initial boiling point and boiling
range (°C)
Not Available
Molecular weight (g/mol)
Not Available
Flash point (°C)
Not Available
Evaporation rate
Not Available
Explosive properties
Not Available
Flammability
Not Available
Oxidising properties
Not Available
Upper Explosive Limit (%)
Not Available
Surface Tension (dyn/cm or
mN/m)
Not Available
Lower Explosive Limit (%)
Not Available
Volatile Component (%vol)
Not Available
Vapour pressure (kPa)
Not Available
Gas group
Not Available
Solubility in water
Immiscible
pH as a solution (Not
Available%)
Not Available
Vapour density (Air = 1)
Not Available
VOC g/L
Not Available
SECTION 10 Stability and reactivity
Reactivity
See section 7
Chemical stability
Unstable in the presence of incompatible materials.
Product is considered stable.
Possibility of hazardous
reactions
See section 7
Conditions to avoid
See section 7
Incompatible materials
See section 7
Hazardous decomposition
products
See section 5
SECTION 11 Toxicological information
Information on toxicological effects
Inhaled
The material can cause respiratory irritation in some persons. The body's response to such irritation can cause further lung damage.
Ingestion
Accidental ingestion of the material may be damaging to the health of the individual.
Skin Contact
This material can cause inflammation of the skin on contact in some persons.
The material may accentuate any pre-existing dermatitis condition
Skin contact is not thought to have harmful health effects (as classified under EC Directives); the material may still produce health damage
following entry through wounds, lesions or abrasions.
Open cuts, abraded or irritated skin should not be exposed to this material
Entry into the blood-stream, through, for example, cuts, abrasions or lesions, may produce systemic injury with harmful effects. Examine the skin
prior to the use of the material and ensure that any external damage is suitably protected.
Eye
This material can cause eye irritation and damage in some persons.
Chronic
Long-term exposure to respiratory irritants may result in airways disease, involving difficulty breathing and related whole-body problems.
Skin contact with the material is more likely to cause a sensitisation reaction in some persons compared to the general population.
Substance accumulation, in the human body, may occur and may cause some concern following repeated or long-term occupational exposure.
J-B Weld Original Syringe Part
A
TOXICITY
IRRITATION
Not Available
Not Available
bisphenol A diglycidyl ether
polymer
TOXICITY
IRRITATION
dermal (rat) LD50: >1200 mg/kg
[2]
Not Available
Oral (Mouse) LD50; >500 mg/kg
[2]
bisphenol F diglycidyl ether
copolymer
TOXICITY
IRRITATION
dermal (rat) LD50: >400 mg/kg
[2]
Eye: no adverse effect observed (not irritating)
[1]
Version No:
6.7
Page
5
of
9
J-B Weld Original Syringe Part A
Issue Date:
10/24/2022
Print Date:
10/24/2022
Continued...