Manual

INFORMATION FIGURES

Direction for Assembly

The Saiga comes fully assembled. All you will need to do is remove the wrapping,

clean the protective oil from the gun and insert the magazine.

Screw in Chokes for shotguns: (This is an option )

SHOTGUN CHOKE TUBE INFORMATION

Each Choke tube is marked with the choke symbols:

The choke tube threads: “Saiga-410ga are LH, “Saiga-20ga & 12ga are RH.

** For steel shot or slug use Cylinder or Improved Cylinder tube.

Make sure that you fully install the choke tube before you fire the shotgun. Make

sure that you do not cross thread the choke tube and after use remove the choke

tube and clean the choke tube threads and location on the barrel where the choke

tube threads to.

To load your Firearm

1. Make sure the firearm is pointed in a safe direction at all times, the safety is

engaged, and never allow fingers or objects to contact trigger.

2. Do not load firearm until you are ready to fire.

3. Remove magazine if it is not already removed

4. Do not disengage the safety.

5. Make sure the ammo that you are using is the correct size and gauge. The

receiver is marked with the gauge/chamber size or caliber, shotgun barrels marked

3" will also use 2 3/4" or 3" shot shells.

6. Visually inspect the chamber for obstructions by moving the bolt back and

looking into the chamber. The chamber should be free of oil or grease or

obstructions... The chamber is the rear portion of the barrel where the cartridge

slides into from the pressure applied by the bolt.

Full

Mod

Improve/Mod

Improved Cylinder

Cylinder

Saiga-410

Saiga-20 Saiga-12

F (0.9)

M (0.5)

IC (0.25)

C (0.0)

IC (0.25)

M (0.5)

F (0.9)

Chokes