Manual

W A R N I N G

BEFORE LOADING or firing a firearm, examine the bore and the firing chamber to

be certain they are clean and free of any obstruction. Even a heavy coat of oil,

grease, snow or water may result in damage to the firearm and injury to the shooter

and/or persons near the firearm. A misfire or unusual sound upon firing is a signal

to cease firing and to examine the chamber and bore. If there is any obstruction,

clear the obstruction and clean the bore and chamber before firing.

FIRING WARNING

When shooting, full eye and ear protection is mandatory at all times. Shooters

and spectators must wear shooting glasses and sound suppressor to prevent

eye injury and hearing loss. Vision loss and hearing impairment can occur with

only one moment of non-protection.

W A R N I N G

Any bore obstruction, even if it is only partly blocked, may cause the gun to blow

up if it is fired, or may cause damage to the gun such as a bulged barrel. To

avoid injury or death to the shooter or bystanders, check the barrel before

shooting or if a shot does not sound normal.

W A R N I N G

Always keep the muzzle pointed in a safe direction! Never attempt to load or

unload any firearm inside a vehicle, building or other confined space (except a

properly constructed shooting range). Enclosed areas frequently offer no

completely safe direction in which to point the firearm. If an accidental

discharge occurs, there is great risk of injury or property damage. Before

loading, always clean all, grease and oil from the bore and chamber, and check

to be certain that no obstruction is in the barrel. Any foreign matter in the barrel

could result in a bulged or burst barrel or other damage to the firearm and could

cause serious injury to the shooter or to others.

W A R N I N G

If there is any reason to suspect that a bullet or projectile is obstructing the

barrel, immediately unload the firearm (See Unloading Instructions) and check

the chamber and the bore. A bullet may be lodged some distance down the

barrel where it can not easily be seen. Check the bore by using a cleaning rod

to pass through the barrel. If a blockage is in the bore, DO NOT ATTEMPT TO

SHOOT IT OUT WITH ANOTHER CARTRIDGE, OR BLOW IT OUT WITH A

BLANK CARTRIDGE OR A CARTRIDGE FROM WHICH THE BULLET HAS

BEEN REMOVED. SUCH TECHNIQUE(S) CAN GENERATE EXCESSIVE

PRESSURE, DAMAGE THE FIREARM AND CAUSE SERIOUS PERSONAL

INJURY. If the blockage can be removed with a cleaning rod, clean any

unburned powder grains from the bore, chambers & mechanism before

resuming shooting. If the blockage can not be dislodged by tapping it with a

cleaning rod, take the firearm to a gunsmith.