Manual

13
Figures 16a, 16b.
W A R N I N G !
The magazine cap is under
spring pressure. Note:
After assembly of the
shotgun the spring in the
magazine tube may become twisted. This will cause a
decrease in magazine tube capacity. If you load and
unload the magazine tube the spring will untwist and
the capacity should be as defined in the manual.
2) If the plastic spring cap is not installed in the
magazine tube, use a small pin in the hole in the
end of the magazine tube to hold the spring during
removal of the cap. Unscrew the cap until you see
the hole in the tube. Then insert the pin through
the hole and hold the spring. See Figure 17.
3) Remove the fore end from the magazine tube. See
Figure 18.
4) Remove the barrel from the box and remove the
plastic bag from the barrel. Insert the barrel
extension into the receiver (between the bolt and
the receiver) while making sure the barrel lug is
aligned with the magazine tube. Continue sliding
the barrel extension into the receiver and allow the
barrel lug to slide over the magazine tube. With
the barrel extension partially inserted into the
receiver between the bolt and the receiver, pull the
bolt cocking handle to the rear so that the bolt is
locked back. Now completely insert the barrel
extension into the receiver. See Figure 19.
5) Slide the fore end over the magazine tube. Do
NOT force the fore end. Make sure that the fore
end is completely seated around the magazine
tube, barrel, and the receiver. The fore end MUST
be flush with the receiver. See Figure 20.
6) Screw on the fore end cap so that the fore end is
held firmly in place and flush against the receiver.
See Figure 21.
7) With the fore end and the barrel in place and the
Figure 16a
Figure 16b
Figure 19
Figure 18
Figure 20
Figure 21
Figure 17