Manual

12
cocked, the bolt will not lock back in the rearward position unless this button has
been pushed rearward.
The Fore End Cap: The fore end cap is located on
the end of the magazine tube at the front of the fore
end and under the barrel. See Figure 13. The fore
end cap screws onto the magazine tube using a right-
hand thread.
W A R N I N G !
The fore end cap is under spring pressure. Use
caution when screwing and unscrewing the fore end cap onto the end of the
magazine.
The Serial Number: The semi-auto shotgun’s serial number is located on the
left bottom side of the receiver.
The Cocking Indicator:
The cocking indicator is
located in the front inside
of the trigger guard. See
Figure 14a. When cocked
the indicator is visible.
When fired or uncocked, the
indicator is not visible. See
Figure 14b.
Directions For Assembly Of Semi-Auto Shotgun:
W A R N I N G
Before you begin to assemble the semi-auto shotgun,
you MUST (1) look down the barrel from the breech
end toward the muzzle end to make sure there is no
ammunition in the chamber or obstruction in the barrel
(See Figure 15), and (2) make sure the safety is in
the “safe” position.
Your semi-auto shotgun was shipped with the barrel
detached from the main portion of the shotgun. To
assemble the semi-auto shotgun, follow these instructions:
1) When you open the box of your new MP153 shotgun, the barrel is separated
from the main portion of the shotgun. To attach the barrel, first remove the
stock and receiver from the plastic bag. Then unscrew the fore end cap. See
Figure 13
Figure 15
Figure 14a
Figure 14b