Owner's Manual

5
MAINTENANCE
Before doing any maintenance on your airgun, make sure it’s unloaded.
Lubricate the air compression chamber with a high-ashpoint oil designed
specically for use inside an air compression chamber. Lubricate the piston seal
through the air transfer port, located on the inside bottom of the barrel breech
when the magazine has been removed from the IZH 61 or when the bolt has been
pulled back on the IZH 60. Oil the airgun (3 to 5 drops) after every 2,000 shots.
Also, lightly oil the cocking arm linkage and bolt pivot points with machine
oil every six months.
Do not use rearm cleaners or low-ashpoint oils in the air compression
chamber or near the transfer port and breech seal to avoid damaging your airgun.
To lubricate the mainspring, remove the stock. Turn over the action and
apply 6 to 10 drops of a light oil onto the spring. Reattach the stock. Oil your gun
every 2,000 to 3,000 shots or every six (6) months. Don’t use too much oil. Using
too little is better than too much.
If you feel additional maintenance is required,
contact Air Venturi at 216-220-1180.