Manual

9
WARNING (Mechanical Malfunctions)
STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR FIREARM if your
firearm develops: a mechanical malfunction; binding or stoppage; spitting
powder/gas; a cartridge primer is punctured; a cartridge case is bulged or
ruptured; or the sound on firing does not sound quite right. Do NOT try one
more shot but unload your firearm and take it and the ammunition to a qualified
gunsmith or send it back to EAA for examination. Do not assume that the
Combination Rifle / Shotgun is empty merely because you checked the chamber.
You must also check the bore for any fired shot or wad jammed inside the barrel.
EXTERNAL CONTROL PARTS:
Trigger Block Safety : Located on the receiver tang behind the top lever, slide
button style. When the Red Dot is showing the Combination Rifle / Shotgun will
fire when the trigger is pulled!! Do not disengage safety unless you are ready
to fire the Combination Rifle / Shotgun. (Safety Engaged - The Red Dot covered
and the trigger is blocked from full travel; Safety Disengaged - The Red Dot
showing and the trigger has full travel...MAKE SURE YOU UNDERSTAND
HOW THE SAFETY WORKS BEFORE YOU LOAD OR USE THE Combination
Rifle / Shotgun)
Top Lever: Located on top of the receiver, push to right to break open barrel
from receiver of Combination Rifle / Shotgun.
Trigger: Located in the trigger guard. If the safety is disengaged and hammer
mechanism has been cocked and trigger is pulled to the rear the Combination
Rifle / Shotgun will discharge, if there is a live cartridge in the chamber. The
front trigger is for the Shotgun barrel (Bottom Barrel). The back trigger is for the
rifle barrel ( Top Barrel). In the case of a single selectable trigger, one trigger is
used to fire each barrel. Barrel sequence for firing is done by the barrel selector,
see barrel selector section.
Barrel Selector: The trigger of a single trigger(selectable) Combination Rifle /
Shotgun is the barrel selector. If you push the trigger forward until you feel a
click the barrel selection will be top barrel first then bottom barrel. Once you
have moved the top leaver the selection goes back to bottom barrel then top
barrel. Thus, the gun is set to fire the bottom barrel first and then the top barrel,
as configured by the factory, and is only override able by the selector and
movement of the top leaver puts the gun back to the factory configuration.
Forend: Located below barrels in front of receiver, locks barrel assembly into
receiver, has a latch in the mid lower section that is used to lock and unlock
forend.
Rear Sight: Windage adjustable
Scope Mount Rail: