Manual

To Unload Combination Rifle / Shotgun:

• 1) Make sure the gun is pointed in safe direction and the trigger block

safety is engaged

There is no excuse for not being careful.....

• 2) After completing step one completely... push the top lever to the right till

the action breaks open.

• 3) Then fully open the action and remove the shell and cartridge.

• 4) Visually check that the barrels are free of obstructions and then close

the Combination Rifle / Shotgun action.

• 5) We suggest that you remove the hammers spring compression by

pulling each trigger or in the case of a single trigger gun pulling the trigger

for each barrel.

• 6) Make sure the trigger block safety is engaged after the Combination

Rifle / Shotgun action is closed

To Disassemble The Combination Rifle / Shotgun:

• 1) Make sure the Combination Rifle / Shotgun is unloaded (FOLLOW

UNLOADING INSTRUCTIONS) and pointed in a safe direction.

• 2) Make sure the trigger block safety is engaged.

There is no excuse for not being careful.....

• 3) Remove the forend from the barrel by pulling out the lever in the lower

center of the forend and removing the forend in a downward out ward swing

motion. Never force the forend off the barrel and receiver.

• 4) With the barrel and receiver supported with one hand push the top lever

to the right fully and tip the barrel down until it disengages from the receiver.

Check the barrel for damage and blockage after removal

MANUFACTURER’S WARNING

This firearm was manufactured to properly perform with the original parts as

designed. It is your duty to make sure any parts you buy are correctly installed

and that neither replacements nor originals are altered or changed. Your gun

is a complex tool with many parts that must relate correctly to other parts for

safe and accurate operation. Putting a gun together wrong or with modified

parts can result in a damaged gun, injury or death to you or others through

malfunction. Always let a qualified gunsmith work on your gun or at least,

check any work not performed by a gunsmith. Firearms safety is your primary

concern. THE GUN OWNER MUST ACCEPT FULL RESPONSIBILITY FOR

THE CORRECT REASSEMBLY AND FUNCTIONING OF THE FIREARM

AFTER ANY DISASSEMBLY OR REPLACEMENT OF PARTS.