Manual

10
Directions For Assembly Of
Combination Rifle/Shotgun:
• 1) Fig 1: When you open the box of your new
IZH94 “Sever” Combination Rifle / Shotgun the
barrel and forend is separated from the main
portion of the Combination Rifle / Shotgun. To
attach the barrel and forend first remove the
plastic bags or wrapping covering the parts.
Then remove the forend from the barrel by
pulling out the lever in the lower mid section of
the forend and tipping the forend out and
away from the barrel while pulling the lever
out. Never force the forend off the barrel.
Check to make sure that the barrel is free of
foreign matter by looking down the barrel (no
blockage what-so-ever)
• 2) Fig 2: Now push the top lever to the right
and hold. Do not force the top lever.
• 3) Fig 3: Engage the lower locking lug
located on the lower portion of the barrel with
the receiver. The half round cut out on the
lower locking lug fits around the round bar in
the forward lower portion of the slot in the
receiver. With the barrel engaged into the
receiver you should be able to swing the
barrel up into the locked position and the top
lever should move back to the center once the
barrel is locked into position. Note: The top
latch may not move completely to the center
on a new Combination Rifle / Shotgun until the
gun is broken in. The latch must move at least
three quarters of the full travel distance.
• 4) Fig 4: With the barrel locked into the
receiver pull the forearm latch out and place
the forend on receiver. With an upward swing
motion lock the forend onto the barrel. Do not
force the forend into it’s locked position on the
barrel. It may also be required to slide the
forend onto the barrel and then insert it into
the receiver and lock it with an up swing.
Sometimes it is necessary to push the latch
into it’s final flat position, never force the latch
into position.
• 5) Warning... Never fire the gun unless the