Manual

10
Directions For Assembly Of Double
Rifle:
• 1) Fig 1: When you open the box of your new
IZH94 Double Rifle the barrel and forend is
separated from the main portion of the Double
Rifle. To attach the barrel and forend first
remove the plastic bags or wrapping covering
the parts. Then remove the forend from the
barrel by pulling out the lever in the lower mid
section of the forend and tipping the forend
out and away from the barrel while pulling the
lever out. Never force the forend off the barrel.
Check to make sure that the barrel is free of
foreign matter by looking down the barrel (no
blockage what-so-ever)
• 2) Fig 2: Now push the top lever to the right
and hold. Do not force the top lever.
• 3) Fig 3: Engage the lower locking lug
located on the lower portion of the barrel with
the receiver. The half round cut out on the
lower locking lug fits around the round bar in
the forward lower portion of the slot in the
receiver. With the barrel engaged into the
receiver you should be able to swing the
barrel up into the locked position and the top
lever should move back to the center once the
barrel is locked into position. Note: The top
latch may not move completely to the center
on a new Double Rifle until the gun is broken
in. The latch must move at least three quarters
of the full travel distance.
• 4) Fig 4: With the barrel locked into the
receiver pull the forearm latch out and place
the forend on receiver. With an upward swing
motion lock the forend onto the barrel. Do not
force the forend into it’s locked position on the
barrel. It may also be required to slide the
forend onto the barrel and then insert it into
the receiver and lock it with an up swing.
Sometimes it is necessary to push the latch
into it’s final flat position, never force the latch
into position.
• 5) Warning... Never fire the gun unless the
barrel is locked into position on the receiver