Manual

2) Make sure you are wearing eye and ear protection.
3) Keep your fingers away from the trigger(s).
4) Cock hammers per Cocking Instructions.
5) Push the trigger block safety to the “off” or
“fire” position with the red dot showing. See
Figure 29b.
6) With the butt stock held firmly again your shoulder
and the barrels pointed towards your intended
target, place your trigger finger on the trigger. The
shotgun will fire when you pull or squeeze the
trigger with the requisite force. See Figure 30.
7) When you are using a double-trigger, move your
finger to the other trigger and pull it. The second
round will now fire.
W A R N I N G
Once you have fired the shotgun, immediately push
the trigger block safety to the “on” or “safe” position.
Then follow the unloading instructions above while
keeping the muzzle pointed in a safe direction.
DIRECTIONS FOR DISASSEMBLY OF THE
SHOTGUN:
1) Make sure the shotgun is unloaded (FOLLOW
UNLOADING INSTRUCTIONS) and pointed in
a safe direction.
2) Make sure the trigger block safety is engaged in
the “on” or “safe” position. See Figure 31.
3) Remove the fore end from the barrels by pulling
out the mechanical lever in the lower center of
the fore end and removing the fore end in a
downward outward swinging motion. See
Figure 32. Never force the fore end off the
barrels and receiver.
4) With the barrels and receiver supported with one
hand, push the top lever to the right fully and tip
the barrels down until they disengage from the
receiver. Check the barrels for damage and
blockages after removal. See Figures 33(a, b).
18
Figure 29b
Figure 30
Figure 31
Figure 32
Figure 33a
Figure 33b