Manual

Directions For Assembly Of Shotgun:

W A R N I N G

Before you begin to assemble the shotgun, you MUST (1) look down the barrels

from the breech end toward the muzzle end to make sure there is no ammunition

in the chambers or obstructions in the barrels, and (2) make sure the safety is in

the “safe” position.

Your shotgun was shipped with the barrel assembly (barrels and fore end) detached

from the receiver assembly. To assemble the shotgun, follow these instructions:

1) Remove the plastic bags or wrapping covering

the parts. Then remove the fore end from the

barrel by pulling outward on the mechanical lever

in the lower midsection of the fore end and tipping

the fore end out and away from the barrel. See

Figure 15.

2) Now push the top lever to the right and hold

with one hand. Do not force the top lever.

See Figure 16.

3) Holding the barrels with other hand, engage the

lower locking lug located on the lower portion

of the barrels with the receiver. The half-round

cut out on the lower locking lug fits around the

round bar in the forward lower portion of the slot

in the receiver. With the barrels engaged into the receiver, swing the barrels

up into the locked position. The top lever should move back to the center

once the barrels are

locked into position.

Note: The top lever

may not move

completely to the

center on a new

shotgun until the gun is

broken in. The top

lever must move at

least three quarters of

its full travel distance.

See Figure 17 (a, b,

c, d).

4) Now that the barrels

have been locked into

the receiver, you must

Figure 15

Figure 16

Figure 17a

Figure 17b

Figure 17c Figure 17d