Manual

W A R N I N G
Do not touch the trigger(s) while moving the safety. When operating the safety,
make sure you push or pull it to the full extent of its travel in the desired direction,
either fully “on” or fully “off.” Half-safe or partially-safe is UNSAFE.
W A R N I N G
The shotgun is designed to and WILL FIRE when the trigger is pulled and the
safety mechanism is in the “off” or “fire” position.
Top Lever: The top lever is located just forward of
the safety mechanism. See Figure 8. The top lever
is used to break open the action to load and/or
unload the shotgun, and to assemble and
disassemble the shotgun. To break open the action,
fully push the top lever to the right. See Figure 9.
The safety will engage when the top lever is pushed
to the right when opening the barrels.
W A R N I N G
When operating the top lever, you must: (1) make
sure the safety mechanism is in the “on” or “safe”
position; (2) keep your fingers away from the trigger(s)
and outside of the trigger guard; and (3) control the
direction of the muzzle of the shotgun.
Trigger(s): Model IZH43KH shotguns are available
in a double-trigger configuration. See Figure 10.
W A R N I N G
Never pull the trigger(s) until you are actually ready to fire. Keep your fingers off
the trigger(s) and outside of the trigger guard until you are ready to pull the trigger
and fire the shotgun. When opening and closing the action and when engaging or
disengaging the safety mechanism, make sure your fingers are outside the trigger
guard and away from the trigger(s).
Model IZH43KH shotguns are patterned after classic
side-by-side shotguns with two triggers. The front
trigger always fires the right barrel. The back trigger
always fires the left barrel. Pulling either trigger with
the safety in the “off” or “fire” position fires the shotgun.
Figure 9
Figure 8
Figure 10
11