Manual

3) Make sure the barrel assembly is locked into the

receiver and the action closed. The top lever should

now be in the center position. Remove the forend

from the barrels by pulling out the mechanical lever

in the lower center of the forend and removing the

forend in a downward outward swinging motion. See

Figure 38. Never force the forend off the barrels

and receiver.

4) With the barrels and receiver supported with one

hand, push the top lever fully to the right and tip the

barrel assembly down until it disengages from the

receiver. Check the barrels for damage and

obstructions after removal. See Figure 39.

MANUFACTURER’S WARNING:

This firearm was manufactured to properly perform with the original parts as

designed. It is your duty to make sure any parts you buy are correctly installed

and that neither replacements nor originals are altered or changed. Your gun is

a complex tool with many parts that must relate correctly to other parts for safe

and accurate operation. Putting a gun together wrong or with modified parts can

result in a damaged gun, or personal injury or death to you or others. Always let

a qualified gunsmith work on your gun or at least, check any work not performed

by a gunsmith. Firearms safety is your primary concern. THE GUN OWNER

MUST ACCEPT FULL RESPONSIBILITY FOR THE CORRECT

REASSEMBLY AND FUNCTIONING OF THE FIREARM AFTER ANY

DISASSEMBLY OR REPLACEMENT OF PARTS.

TO CLEAN AND MAINTAIN YOUR SHOTGUN:

A) Follow procedures for unloading shotgun as described previously.

B) Follow procedures for disassembly of shotgun as described previously.

C) Materials needed to clean this shotgun are: a cleaning rod, cotton bore

patches, brass bore brush, powder solvent, a small soft brush and good quality

gun oil.

WARNING: Lead or lead compounds are known to the State of California

to cause cancer, birth defects, reproductive toxicity, and other serious physical

injury. Those who clean firearms should take protective measures to avoid

contact or exposure to such chemicals.

D) Using the bore brush with powder solvent, scrub the interior of the barrels

and chambers to remove any powder and lead residue in the bore. Always and

lastly, swab the interior of the barrels with cotton patch with gun oil to coat and

protect the bore and chambers from rust and corrosion.

Figure 38

Figure 39