Manual

TO UNLOAD:

1) Break open the shotgun by pushing the top lever of the receiver all the way

to the right and tipping the barrels down. See Figure 31.

2) Remove the shell(s) from the chamber(s) by grabbing them by the rims and

pulling them from the chambers. See Figure 32.

3) Visually check the barrels to make sure that they are free from obstructions.

See Figure 33.

FIRING YOUR SHOTGUN

W A R N I N G

Never load a cartridge into the chamber until

you are ready to fire the shotgun.

W A R N I N G Do not disengage the trigger block safety until the

shotgun is pointed in a safe direction and you are ready to fire.

W A R N I N G If a cartridge does not fire and the trigger has been pulled

and the trigger block safety is disengaged, Stop! Then do the following: a)

Make sure the gun is pointed in a safe direction b) Engage the trigger block

safety c) Wait 60 seconds d) Follow the instructions above for unloading the

shotgun.

W A R N I N G

If during firing the sound of any cartridge is noticeably softer or louder than the

previous cartridge fired, Stop! Then do the following: a) Make sure the gun is

pointed in a safe direction b) Engage the trigger block safety c) Follow the

instructions above for unloading the shotgun and d) With the shotgun unloaded

visually inspect the shotgun for barrel blockage or damage. Then inspect the

receiver of the shotgun for damage before continuing.

Figure 33

Figure 32Figure 31