Manual

12
W A R N I N G
Never fire a double-trigger shotgun by using two fingers because you may
inadvertently pull both triggers at the same time resulting in a near simultaneous
firing of both barrels. Use your index finger to pull one of the triggers to fire the
first shot. After that shot is fired, release the trigger and move your index finger
to the other trigger to fire the second shot.
Single-trigger IZH27 shotguns have a single trigger which is used to fire each
barrel. Once the trigger is pulled to fire the first barrel, release the trigger. The
second barrel is then ready to be fired by pulling the trigger again.
The Ejectors: The IZH27 shotguns are equipped with ejectors which are preset
at the factory for automatic ejection of fired rounds upon opening of the action.
However, the ejectors may be adjusted by the user to disable the automatic-
ejection feature. When the ejectors are set in the disabled position, fired shells
will not be automatically ejected from the barrels when the action is opened.
The ejectors are controlled
by set screws located on
the curved portion at the
front of the receiver. The
right side set screw
controls the ejection of
shells from the bottom
barrel. See Figure 12.
The left side set screw controls the ejection of shells from the top barrel. See
Figure 13.
The set screws for the
ejectors are preset at the
factory for automatic
ejection of fired shells
when the action is
opened. In the automatic
setting, the slots in the set
screws are oriented in a
vertical position running perpendicular to the length of the barrels. See vertical
positioning of slots as depicted in Figures 14 and 15.
To disable the automatic
ejectors, open the action
and turn the set screws
clockwise ˘ of a turn so
that the set screw slots are
in a horizontal position
parallel to the length of the
barrels. See Figures 16
and 17.
Figure 16
Figure 17
Figure 13Figure 12
Figure 15
Figure 14