Manual

NOT ATTEMPT TO SHOOT IT OUT WITH ANOTHER CARTRIDGE, OR

BLOW IT OUT WITH A BLANK CARTRIDGE OR A CARTRIDGE FROM

WHICH THE SHOT HAS BEEN REMOVED. SUCH TECHNIQUE(S) CAN

GENERATE EXCESSIVE PRESSURE, DAMAGE THE FIREARM AND CAUSE

SERIOUS PERSONAL INJURY. If the blockage can be removed with a cleaning

rod, clean any unburned powder grains from the bore, chambers and mechanism

before resuming shooting. If the blockage cannot be dislodged by tapping it with

a cleaning rod, take the firearm to a gunsmith.

W A R N I N G (EYE AND EAR PROTECTION)

When shooting, full eye and ear protection is mandatory at all times. Shooters

and spectators must wear shooting glasses and hearing protection to prevent

eye injury and hearing loss. Vision and hearing impairment can occur with only

one moment of non-protection.

W A R N I N G (Mechanical Malfunctions)

STOP SHOOTING IMMEDIATELY AND UNLOAD YOUR FIREARM if your

firearm develops: a mechanical malfunction; binding or stoppage; spitting powder/

gas; a punctured cartridge primer; a bulged or ruptured cartridge case; or a

sound on firing does not sound quite right. Do NOT try one more shot but unload

your firearm and take it and the ammunition to a qualified gunsmith or send the

firearm back to European American Armory Corp. for examination. Do not

assume that the shotgun is empty merely because you checked the chamber.

You must also check the bore for any fired shot or wad jammed inside the

barrel.

BASIC PARTS OF YOUR SHOTGUN

EXTERNAL CONTROL PARTS:

Trigger Block Safety: The safety mechanism of the shotgun provides protection

against accidental and unintentional discharge under normal

usage when properly engaged and in good working order.

The safety mechanism is not a substitute for following the

rules of safe gun handling. Do not disengage the safety

unless you are ready to fire the shotgun. MAKE SURE YOU

UNDERSTAND HOW THE SAFETY WORKS BEFORE

YOU LOAD OR USE THE SHOTGUN.

The safety mechanism is a tang-style safety located behind

the top lever. See Figure 6. To place the safety in the “on”

Figure 6