Instructions
Table Of Contents
- 1 User Guide
- 2 Safety Instructions
- 3 Scope of Delivery
- 4 Product Description
- 5 Installation
- 6 Configuration
- 7 Operation
- 8 Default Network Settings
- 9 Default TCP/UPD Ports
- 10 Technical Data
- 11 Support/Return Hardware
- 12 Disposal
- A Regulatory Compliance
Configuration 14 (30)
► If the connected device is not found, see Scanning for Devices with Unknown IP Addresses, p.
14 for more information.
► Select the type of CAN@net NT in use in drop-down list Select device type (2).
► Select the firmware version of the device in drop-down list Select device version (3).
► Select the desired operational mode for the device in use in drop-down list Select
operational mode (4).
► Connect the device in the CAN-Gateway Configurator (see Connecting the Device in CAN-
Gateway Configurator, p. 15).
6.2.2 Scanning for Devices with Unknown IP Addresses
If the IP address of a device that is connected via Ethernet is unknown or invalid in the local
network, the device can be found via menu Scan — IP configuration.
Device is only found by scanning, if correct device type and firmware version are selected.
Make sure, that device type and firmware version are selected according to the
connected device.
HMS Industrial Networksrecommends to use a static IP address.
► Select the type of CAN@net NT in use in drop-down list Select device type (2).
► Select the firmware version of the device in drop-down list Select device version (3).
► Open menu Scan and select IP configuration.
→ CAN-Gateway Configurator scans automatically for connected devices of predefined
type and firmware version.
→ Connected devices of the selected type and firmware version are shown.
Fig. 9 IP configuration
CAN@net NT User Manual
4.01.0332.20000 1.6 en-US