Instructions
Table Of Contents
- 1 User Guide
- 2 Safety Instructions
- 3 Scope of Delivery
- 4 Product Description
- 5 Installation
- 6 Configuration
- 7 Operation
- 8 Default Network Settings
- 9 Default TCP/UPD Ports
- 10 Technical Data
- 11 Support/Return Hardware
- 12 Disposal
- A Regulatory Compliance
Installation 8 (30)
5 Installation
5.1 Installing the Software
5.1.1 Installing the Driver
For the operation of the CAN-Gateway Configurator and the CAN@net VCI mode a driver is
needed.
The VCI driver is constantly improved and expanded! Check if a newer version is available within the
support area on www.ixxat.com.
► Install the VCI driver (see Installation Guide VCI Driver).
5.1.2 Installing the CAN-Gateway Configurator
The CAN-Gateway Configurator is constantly improved and expanded! Check if a newer version is
available within the support area on www.ixxat.com.
► Download the CAN-Gateway Configurator CANbridge NT & CAN@net NT 200/420 package
from www.ixxat.com.
► Run cangwconfig.exe.
→ Installation wizard starts automatically.
► Follow instructions in installation program.
5.2 Installing the Hardware
Fig. 4 Connectors
1 CAN 1
2 CAN 2
3 Power connector
4
CAN 3 (only with CAN@net NT 420)
5
CAN 4 (only with CAN@net NT 420)
► Make sure that the cross-sectional area of the cable is larger than or equal to 0.14 mm
2
resp.
25 AWG.
► To remove the connector, use screwdriver or similar tool.
► Connect the cables.
► Plug the connector into the housing.
3
1
2
4 5
CAN@net NT User Manual
4.01.0332.20000 1.6 en-US