Instructions

Error Codes (RET) 63
Doc.Id. HMSI-216-117
CM CANopen Module for SIMATIC S7-1200
Doc.Rev. 1.00
45 1X DB could not be deleted because it was created with the keyword
UNLINKED (S7-400 only).
X specifies the offset from DBSTART where the error occurred
SFC24 80B2
2X DB could not be deleted because it is stored on a flash card.
X specifies the offset from DBSTART where the error occurred
SFC24 80B3
3X DB can not be deleted. Possible causes:
• It belongs to an F-program
• It is an instance DB of a block for S7 communication (S7-400 only)
• It is a technology DB
X specifies the offset from DBSTART where the error occurred
SFC24 80B4
4X The DB with the specified number does not exist in the CPU.
X specifies the offset from DBSTART where the error occurred
SFC24 80B1
46 1X There is not enough free memory available.
X specifies the offset from DBSTART where the error occurred
SFC22 80B2
2X There is not enough continuous memory space available. Compress mem-
ory.
X specifies the offset from DBSTART where the error occurred
SFC22 80B3
47 0X The length of the DB is not equal to the DBSIZE input parameter and has
not been created using the download block.
X specifies the offset from DBSTART where the error occurred
- -
48 00 DBSIZE must be in the range 262 - 50000 - -
49 00 DBSIZE must be an even number - -
4A 00 Slot must be in range 0 - 7 - -
51 00 No DP module/PROFINET IO device from which you can read consistent
data exists at the logical address specified in LADDR.
SFC14,
SFC15
8093
52 00 Access error detected while I/O devices were being accessed. SFC14 80A0
SFC15 80A1
53 00 Slave failure on external DP interface module. SFC14,
SFC15
80B0
54 00 The length of the specified destination area is not identical to the user data
length configured with STEP 7.
SFC14,
SFC15
80B1
55 00 The data of the previous read/write job on the module have not yet been
processed by the module.
SFC14 80C0
SFC15 80C1
56 00 System error with external DP interface module. SFC14,
SFC15
808X,
80B2,
80B3,
80C2,
80FX,
87XX
Error
code
a
Additional
error code
a
Description
SFC/SFB
number
b
RET_VAL
b