User's Manual

錯誤 ! 尚未定義樣式。
錯誤! 尚未定義樣式。 97
RF Exposure
Tests for Specific Absorption Rate (SAR) are conducted using standard
operating positions specified by the FCC with the device transmitting
at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level,
the actual SAR level of the device while operation can be well below
the maximum value. This is because the device is designed to
operate at multiple power levels so as to use only the power required
to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output. Before a device model
is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the limit established by the government-
adopted requirement for safe exposure. The tests are performed in
positions and locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. (Body-worn measurements may
differ among device models, depending upon available accessories
and FCC requirements). While there may be differences between the
SAR levels of various devices and at various positions, they all meet
the government requirement for safe exposure. For body worn
operation, to maintain compliance with FCC RF exposure guidelines,
use only accessories that contain no metallic components and
provide a separation distance of 1.5cm (0.6 inches) to the body. Use
of other accessories may violate FCC RF exposure guidelines and
should be avoided.
Health and Safety Information
Exposure to Radio Frequency (RF) Signals
Your wireless device is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. These limits are part of
comprehensive guidelines and establish permitted levels of RF energy
for the general population. The guidelines are based on the safety
standards previously set by both U.S. and international standards
bodies:
 American National Standards Institute (ANSI) IEEE. C95.1-1992
 National Council on Radiation Protection and Measurement
(NCRP). Report 86.1986.