Installation & Assembly

#4
Step 1.
Attach legs (part A) to top panel (part B) using bolts (part #1), flat washers (part #2) and
wrench (part #3).
NOTE: Please fully tighten all bolts at this time.
Lay top panel (part B) upside down on a soft flat surface, such as carpet, as shown below.
Step 2.
Carefully turn unit upright. Attach cap (part #4) to top panel (part B).
#2
x8
#1
#3
x1
x8
3
#1
#2
#3
A
B
B
NOTE: It is important to adjust levelers once fully assembled and upright. Extend adjustable
leveler until it’s firmly in contact with the floor. If relocating, adjust leveler as needed
until it’s firmly in contact with the floor in new location.
#4
x1