Owner Manual

Assembly Instruction

CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel

before beginning installation.

Care and Cleaning

To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never

a solvent) to wipe the surface of the fixture.

To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker

or by removing the fuse at the fuse box. Next, use a dry or slightly dampened clean cloth(use clean

water, never a solvent) to wipe the interior surface of the fixture

Do not use any cleaners with chemical, solvents or harsh abrasives. Use Only a dry soft cloth to dust

or wipe carefully.

Estimated Assembly Time:30 minutes

Part List and Hardware List

PIECE DESCRIPTION PICTURE QUANTITY PIECE DESCRIPTION PICTURE QUANTITY

A Lamp Body 1X H Canopy 1X

B Bulb 6X I Mounting Plate 1X

C Fixture Loop 1X J

Mounting

Screw

D Closable Link 5X K Wire Nut 3X

E Chain 1X L Loop Assembly 1X

F Canopy Nut 1X M Connecting Rod 3X

G Hanging Loop 1X

1/3

PAGE 1
Assembly Instruction CAUTION: Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation. Care and Cleaning To clean the outside of the fixture, use a dry or slightly dampened clean cloth(use clean water, never a solvent) to wipe the surface of the fixture. To clear the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
Installation Step 1 Unpack all parts from cartons carefully. Place the Canopy(H)onto the Hanging Loop(G) Place the tube of Mounting Plate(I)into the theaded portion of the Hanging Loop(G) and fix it by turing the Canopy Nut(F) clockwise till tight. Attach the Closable Link(D) onto the Hanging Loop(G) Step 2 Thread Fixture Loop (C) to Loop Assembly (L).
PAGE 3
*Note: When parallel wire(SPTI&SPTII)is used. The neutral wire is square shaped and ridged and the hot wire will be round in shape and smooth.(See illustration on left) Grounding Instructions: a) For installation in the United States: Wrap ground wire from outlet box around green ground screw on mounting bracket, no less than 2" from wire end. Tighten ground screw. If fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.