Owner Manual

①
②
①
④
②
①
②
① ①
②
Unihopper DRAWER/HINGE ADJUSTMENT AND REMOVAL
Unihopper general drawer/hinge adjustment and removal
Installation
Adjustment
Removal
Unihopper Quick Assembly Drawer Slide
Installation
Adjustment
Removal
②Insertion
③Slide in
Down
Up
“click”
Front & back adjustment
±1.5mm
Up & Down adjustment
±1.5mm
Left & Right adjustment
±0.5mm
IMPORTANT
1. The drawer slides unsteadily？
To prevent debris from getting into the mechanism while assembling.
Note: Only applies to rebound guide rail
3. Quick assembly failed？
Correct the front and back assembly position of slide
4. Drawers cannot fully close？
Correct the front and back assembly position of slide
5. Fail to remove the drawer？
Turn the quick assembly fittings; Take out the lock pin.
6. Rebound distance not enough？
Cabinet must be put in horizontal position to avoid the slide incline
backward.
7. Drawer fails to rebound？
If the rebound distance less than 4mm,
quick assembly fittings should be adjusted.
2. Cannot work smoothly？
Check if the size of drawer and cabinet meet the requirement;
check the drawer is square or diamond; make sure the slide in level.
Drawer insertion & removal
BLUM DRAWER/HINGE ADJUSTMENT AND REMOVAL
Side Adjustment
Removal
Height Adjustment
Assembly
Removal
Insertion
Blum Hinge Adjustment and removal instruction
Blum Drawer Adjustment and removal instruction
Modul
Adjustment
Height Adjustment Side Adjustment Depth Adjustment
Side Adjustment