Owner Manual

WALL HUNG STORAGE UNIT
Use spirit level, mark &
install all brackets level
Finished
Surface
Finished
Surface
Finished
Surface
FREESTANDING VANITY
Please note all Freestanding storage units must be fixed
into noggin. Using a minimum of 2 screws so as to avoid
storage falling forward.
Place storage unit onto wall, locate noggin and then check
for level. Use screws, caps and boss supplied to fix through holes of
storage into noggin.
Carefully Reinstall mirror doors to
cabinet.
Carefully remove mirror doors
from cabinet
Locate stud in wall, using
measuring tape mark stud centre
on wall
Place mirror box and level at
desired height. Mark out stud
centres on mirror box backing
board.
Use prepacked screws, insert
brass threaded boss and
continue to screw into wall until
all screws firmly holding mirror
box on wall.Screw on chrome
screw caps to brass box.
If cabinets are to be installed
into wall cavity they must NOT
be installed into load baring wall.
Use electric drill to drill holes
at the marked position
Finished
Surface
Finished
Surface
MIRROR CABINETS