Owner Manual

IMPORTANT: All fixing screws that
hold the vanity unit onto the wall
must fix through wall into horizontal
noggin. Failure to do so will result
in vanity falling off wall.
Place vanity onto wall in the desired hight.
Check level from side to side and front to
back. Packers may be required to level
vanity unit and prevent cabinet from twisting
once vanity is level fasten to wall using screws,
cap and boss provided. Installers must check
and adjust to avoid mistakes.
Use spirit level, mark &
install all brackets level
Reverse the carton while unpacking,
cabinet legs upward, turn the leg end
screws.
Note: Do not fix the screws when turn,
left distance used to adjust.
Reverse the cabinet.
Note: The process needs two workers to
avoid the drawers come out.
It’s necessary to measure the cabinet
level to adjust well.
Please note when installing an
undermount basin or counter basin
onto a stone top, they must be
siliconed on. When the silicone has
dried ensure you caulk around the
basin and stone top.
The unit must be sealed along
the back edge of the top and
down the sides against the wall
with non acidic bathroom &
kitchen silicone.
The vanity is now ready for
the tapeware and waste
installation.
FREESTANDING VANITY (WITH ADJUSTING SCREWS)