Owner Manual

*install in wall
horizontal noggin at
framing stage factoring in desired
height of vanity, including vanity
basin (pre cladding stage)
To avoid damage remove cabinet drawers.
Then cover the drawer runners with plastic
sheet to prevent debris from getting into the
mechanism. Refer to page 12-14 for removing
your drawers/doors for Blum/DTC runners.
Non acidic
Kitchen &
Bathroom
Silicone
Non acidic
Kitchen &
Bathroom
Silicone
The unit must be sealed along the
back edge of the top and down the
sides against the wall with non acidic
bathroom & kitchen silicone. Seal
around the cabinet with silicone.
Please note when installing an
undermount basin or counter basin
onto a stone top, they must be
siliconed on. When the silicone has
dried ensure you caulk around the
basin and stone top.
The vanity is now ready
for the tapware and waste
installation.
Pre-cladding
wall stud
Drywall
in wall
horizontal
noggin
(*See below)
Post-cladding
wall stud
Use spirit level to mark all
holes and use proper drill bit
make holes for wooden
mounting bracket.
WALL HUNG VANITY WITH WALL BRACKET SYSTEM FOR HOLLOW WALLS
Drywall
Place the final mounting screws into the "L"
shape bracket. Use anchor if drill position is
not on stud.
Wall
All mounting screws must be tighten on stud.
Place the cabinet on the wall again. Use
electric drill to drive the screws through
the metal L shape and wooden back
panel into the wall.
Spirit Level