Owner Manual

Step 4
Step 6
Step 5
Now proceed to tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially.
Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, adjust the Legs Pre-installed Levellers until the Table is level with the
ground.
Adjust the levellers to the desired height to avoid wobbles.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Carefully place Table Top(A) facedown on a clean, non-marring surface.
Align the Table Legs(C) to mounting positions on Table Top(A).
Attach Table Legs(C) to Table Top(A) using Bolts(②), and Washers(④) with Allen
Key(①).
Do not fully tighten the Bolts.
Page 4 OF 5