Installation Instruction

GND
FIG.1
Back Plate Dimensions
C1
D1
F1
Mounting Screw
Gasket
Wood Screw
4 1/2”
1 3/4”
1 3/8”
G1
E1
A1
B1
Washer
Plastic Anchor
Wire Connector
Junction Box Screw
Junction Box
Mounting Plate
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (C1) and gasket (D1) from the xture.
4. Drill a hole in the wall aligned with the key-hole located in the mounting plate, insert the plastic anchor (E1) to the wall.
5. Secure the mounting plate to the junction box using the junction box screw (B1). Fasten the mounting plate to the wall using the wood
screw (F1) and washer (G1). The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the xture wire to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
7. Place the xture on the mounting plate,
and secure it with mounting screw (C1)
and gasket (D1).
8. To prevent moisture from entering the
outlet box and causing a short, use
clear caulking (i.e. indoor/outdoor
silicone sealant) to outline the outside of
xture back plate where it meets the wall.
Leave a space at the bottom to allow
moisture to escape Fig. 3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box
Caulking
Fig. 3 Sealing
INSTALLATION INSTRUCTION
Outdoor Wall Sconce
We retain the right to modify the design of our products at any time as part of the company's continuous improvement program. 2
9 1/8”
13 3/4”