Assembly Instructions

CAUTION: LED fixtures can operate at high temperatures
please use caution when touching during operation or after
operation.
1. Detach the circular strap from the backplate and mount the circular strap to the
outlet box in you wall using the two screws provided.
ELECTRICAL CONNECTIONS 120V~, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green wire to
green or bare wire or grounding screw on mounting bracket. In all cases grounding
conductor to earth must be used. Use UL/CSA Listed wire connects suitable for the
size, type, and number of conductors. No loose strands or loose wires should be
present. Secure wire connectors with UL/CSA Listed electrical tape.
2. Spread electrical splices so black wires are on one side of outlet box and white
wires on the other.
3. Mount the body of the fixture on the wall by aligning the circular strap wing holes to
side holes of the back plate. Be careful not to pinch any of the wires between the
fixture and the outlet box. Tighten the fixture to the wall by screwing the two screws
into the side holes of the back plate.
The glass will be KD when shipped out. Customer should unscrew the screw &
rubber gasket, then install the glass and reinstall rubber gasket & screw.
4. Once the fixture is mounted on the wall, caulk the space between the wall and
the upper area of the back plate to prevent water seeping into the outlet box. Leave
the bottom area un-caulked for drainage of any water which might leak into the
enclosure.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box.
Turn the light switch on to activate the fixture.
6. For LED replacement, unscrew the screws of glass, then unscrew screws of LED
module. Install new LED module and secure with screws. Reinstall glass cover.