Instructions

Step 11 Step 12
Nipple
Canopy
Upper
Connector
Nut
Loosen the nut on the upper connector and slide it down
the chain towards the lower connector. Slide the canopy
down the chain towards the lower connector. Feed the
wire through nut, canopy, the upper connector and onto
the nipple. Tighten the upper connector onto the nipple.
Spread the other end of the chain open and fasten to the
upper connector. Ensure the opening is closed.
White
Black
House supply
Ground wire
Fixture
Ground
wire
Upper
Connector
Nipple
Connect the ground wires (bare copper or green) from your
fixture to the ground wire (bare copper or green) or ground
screw in the electrical outlet box. Connect the black wire (or
wire marked “SPT-1”) from the fixture to the black wire in
the electrical box and connect the white wire from the
fixture to the white wire in the electrical box.
Step 13 Step 14
Canopy
Nut
Once connections of wires are completed, carefully tuck
wires and wire nuts into the outlet box making sure no
bare wire (on the black and white) is visible at the wire
nuts. Slide canopy into position and tighten in place by
nut into position.
Install proper bulb type and wattage (not included).
Remove the 2 cable ties tightened in Step 2.
3 of 3