Instructions

A2
A2
A2
A2
Step 9 Step 10
Nipple
Outlet Box
Outlet Box Screws
Mounting
Bracket
Hex Nut
Attach the mounting bracket to the outlet box using
electrical box screws (not included) . Attach the nipple to
the mounting bracket and adjust until it will clear the
canopy when assembled (Place the canopy over the nipple
and tighten the upper connector onto the nipple until snug.
The upper connector should hold the canopy snug to the
ceiling). Lock the nipple in the correct position using the
hex nut.
Connector
Lower
Power
Cord
Chain
To attach chain loop to light fixture, use a screwdriver and
wrench to open and close chain loop. Ensure to close the
opening. Weave the power cord and ground wire through
the links in the chain.
Remove the loop, top cover and small tube from fixture
body. Screw the centre rod to the fixture body .
Step 5 Step 6
Step 7 Step 8
Centre Rod
Loop
Loop
Route the cord through the top circle. Place the small
tube and top cover in place. Slightly slide the fixture
body into the fixture. Install the fixture body to the
fixture by tightening the loop against the top cover.
Top
Cover
Top Cover
Small
Tube
Small Tube
Install 4pcs of “A2” in place by tightening the screws.
Install the side cover by tightening the 2 finials against
the screw stem.
Finial
Side Cover
A1
A1
Fixture Body
Fixture Body
Box
Box
Box
2 of 3