Assembly Instructions

Step 4
Your Table is ready for use.
Step 2
Attach Leg Support Panel(C) between Leg Panels(B) using Bolt(②) and Washer(③) with Allen Key(①)
as shown in the picture above.
Repeat the same process to affix the another Leg Support Panel(C)
Do not fully tighten the Bolts.
Step 3
Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, apply steady and even pressure down on the Table with the help of an
adult partner.
Adjust the Legs Pre-installed Levellers until the Tables level with the
ground. Adjust the levellers to the desired height to avoid wobbles.
When the Table is level proceed to tighten all Bolts at all joints.
CAUTION : When tightening these bolts, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the bolts and execute this same drop tests.
WARNING!! IF table IS NOT STABLE , IT COULD LEAD TO DAMAGING THE PRODUCT.
Page 3 OF 4