Assembly Instructions

Step 4
Attach Front Legs(B) to Hind Legs(C) using Bolt(③) and Washer(④) with Allen
Key(①) as shown in the picture.
Do not fully tighten the bolt.
Step 5
Place the Chair on a LEVEL SURFACE to check for wobbles.
If it wobbles lift the Chair to some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Chair freely and vertically with the four legs, hitting the ground, all at the
same time.
This Drop Test will help to ensure that all the bolts and gaps to all reach full
alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles found, slowly and steadily, turn the Chair upside down.
Then, proceed to tighten all bolts in a sequential manner.
CAUTION : When tightening these bolts, tighten sequentially.
DO NOT tighten any bolt fully and then towards the next one.
This would cause the frame to warp.
If there are still wobbles, loosen the bolts and execute this same drop test.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Page 4 OF 5