Instructions
Event Triggered Recording Instructions
When Event triggered Recording (ETR) function is enabled it allows you to choose a lower
resolution for normal recording and a higher resolution for alarm triggered recording. It will then
record based on the resolution, frame rate and bitrate specifications you have selected. This can
help to save hard drive storage.
Instructions:
1. On the NVR Click Setup——Record——Encode, enter into the interface of Mainstream,
enable ETR option
2. After ETR is enabled, the channel will have an additional setting for Alarm recording,
example below for CH1. Save settings
3. When the channel triggers the alarm, the main stream recording will record based on the
setting parameters of the “Alarm“. The following are the video file codec information
saved in the status of no alarm triggered (normal) and with alarm triggered (event).