Warranty
8
INSTALLING YOUR WINE COOLER
INSTALLATION
INSTALLATION
IMPORTANT INSTALLATION NOTES:
• Before installing your wine cooler, allow to stand upright for 3 hours.
• Once the unit is installed and turned on, allow 24 hours before use for
the temperature to stabilize.
• Clean the interior of the unit with warm water and a soft cloth, and
make sure it is dry.
• Place only on a level surface that will support the weight once
Wine Cooler is completely full. You can ensure the unit is level by
placing a small ball on top and checking to make sure it does not
roll in any direction.
• Position in a dry, well-ventilated space with temperatures between 41° –
90° F (5° - 32° C).
• Ensure that the ventilation panel on the bottom front of your wine
cooler remains unobstructed.
• Do not use without feet: the unit requires 2of ground clearance.
• If you are discarding an old unit, remove its door and leave shelves in
place to avoid an entrapment hazard.
INSTALLING THE DOOR HANDLE:
• The unit has been shipped with the door
handles
D
securely stored inside, attached
to the shelves.
• Gently pull the door gasket back from the
screw holes where you will attach the handle.
• Use the two included screws
A
and
washers
B
in order to fasten the door
handle to the frame of the door.
POSITIONING THE UNIT:
• You will want to ensure that the unit will fit properly in your
desired location.
• Opening must be at least 34.3" H x 23.4" D x 25" L.