Use and Care Manual

ASSEMBLY

INSTALLING THE KEG COUPLER

1. Insert the keg coupler into the neck of the beer keg and

turn it clockwise to lock it into position.

2. Make sure the washer is in place in the connector on the

side of the keg coupler, then attach the CO gas line to the

connector.

3. Make sure the washer is in place in the connector on top

of the keg coupler, insert the beer tube into the top of the

keg coupler. Tighten the wingnut.

4. Repeat steps 1-3 if you have a second keg.

5. Pull the black handle on the keg coupler and press

downward until it locks into position. The keg is now

tapped.

ADJUSTING THE CO REGULATOR

Keg coupler

Keg

Pressure release valve

Shut-o valve

Pressure gauge

Set to 10-12 PSI

Adjustment

lock nut

Regulator

screw

CO regulator

CO tank

T-connector

CO gas line