Use and Care Manual

ASSEMBLY

ATTACHING THE GUARDRAIL

Insert the guardrail into the corresponding holes on top of

the kegerator.

INSTALLING THE DRAFT ARM ASSEMBLY

1. Remove the round cabinet plug from the top of the

kegerator. You may need to push the cabinet plug up

from inside the unit. Make sure to store the plug in a safe

place in case you decide to convert the unit to a standard

beverage cooler instead of a kegerator.

a. Place the dual-tap beer-tap gasket over the

opening, aligning the four holes in the

gasket with the holes on top of the unit.

b. Pass the wingnuts and the beer tubes

(attached to the draft arm assembly)

through the opening in the unit until the

draft arm assembly rests comfortably on

top of the cabinet.

c. Align the holes in the draft arm assembly

with the holes in the gasket.

d. Use the four provided screws to attach the draft arm

assembly to the worktop. The ﬁnal assembly should

look like the diagram below:

2. Attach the black plastic beer-tap handle to the top of the

faucet, tightening by hand until it’s secure. Hold the silver

snug ring so it does not move.

NOTE: If there is a small drip after pouring a beverage, the

beer-tap handle may be too tight. If this happens, unscrew

the silver snug ring by one turn, and then re-tighten the

beer-tap handle.

Beer-tap handle

Silver snug ring

Draft arm assembly

Beer tube

Wingnut

Dual-tap beer gasket