Use and Care Manual

INSTALLATION

BEFORE SETUP

1. Prior to connecting the beer dispenser to an outlet,

allow it to stand upright for approximately two (2)

hours. This will reduce the possibility of any cooling

system malfunctions from being handled during

transportation.

2. Clean the interior of the unit with a soft cloth and

lukewarm water.

POSITIONING THE KEGERATOR

• Place your kegerator on a level ﬂoor that is strong

enough to support it with a full keg inside.

NOTE: this appliance is designed to be free-standing

only. It should never be installed as a recessed or built-

in unit.

• Allow 3" (7.62 cm) of space between the back and

sides of the kegerator for proper air circulation to cool

the compressor and condenser.

• Ensure the kegerator is positioned in a location away

from direct sunlight, any heat-generating appliances,

or any other heat sources. Direct sunlight may damage

or aect the acrylic coating, and heat sources increase

power consumption and also can cause a safety hazard.

• Make sure the unit is installed in a place that is not

subject to extreme cold ambient temperatures, as these

can cause it not to function properly.

• Make sure the unit is installed in a location where it will

not be exposed to moisture or excessive humidity.

• Plug the unit into an exclusive, properly installed and

grounded wall outlet. Never, under any circumstances,

cut or remove the grounding prong from the power

cord. Any questions regarding power and/or grounding

should be directed to a certiﬁed electrician or an

authorized product service center.

• Once the unit has been plugged in, allow 2-3 hours

for it to reach the proper cooling temperature before

placing anything in the keg compartment.

⚠ ADDITIONAL ELECTRICAL PRECAUTIONS

• Improper use of the grounded plug can result in the risk of

electrical shock. If the power cord has been damaged, you