Instructions / Assembly

HOW TO ASSEMBLE

1. Insert the handle into the snow scoop body.

2. You will notice that there are two sets of holes you can use to attach the handle, one higher and one lower. Choose

one based on the handle height that feels comfortable to you.

3. Push the handle into the snow scoop body so that your desired

set of holes lines up with the holes in the snow scoop body.

4. Insert the included bolts into the holes, so that the ﬂat end

rests against the interior of the snow scoop body.

5. Working from the exterior of the snow scoop body, thread

the washers onto the bolts.

6. Screw the wingnuts onto the threaded end of the bolts,

making sure they are fully tightened but not over-tightened.

Please note: to use the Snow Scoop, simply push the snow to

your desired location. There’s no need to bend or lift.

Fully Assembled