User Guide

INSTRUCTIONS / OPERATION

INSTRUCTIONS

1. Remove back cover and set to the side. (There is only one screw that

needs to be loosened to take o back cover.)

2. Install the ceramic ozone plate in the ceramic ozone plate slot. Make sure

the ceramic ozone plate is ﬁrmly in place.

3. Place back cover on unit and tighten the screw.

4. Connect the power adapter into the machine then plug into an outlet.

5. Use the ON/OFF button to turn on device. A green light will come on

indicating your device is on.

6. Press the OZONE button to activate the ozone at level I. Press button

again to select a higher setting if necessary. A green light will show you

which ozone level is currently activated. (The ideal amount of O3 will

leave your room smelling clean and fresh. If the unit is set too high, you

will smell too much O3. If it is set too low, you will smell household

odors.)

7. Set timer if you plan to be away for a long time. Use the HOURS button

to have the puriﬁer run for 1, 2, 4 or 6 hours. A green light will show you

which time you have selected. Once the timer runs out, the machine will

automatically turn o. You can set the timer and leave the machine alone

without worry. Once the machine is ﬁnished, wait an hour before entering

the room for the O3 to change back to O2. (If timer is not set, the air

puriﬁer will stay in use until it is manually turned o.)

OPERATION

Optimal Location of Unit Placement: For optimal treatment of air cleansing

in your designated area, your new ozone generator should be placed in a

high central location. Your unit can be set on a tall piece of furniture. Allow

three (3) inches between the back of unit and the wall to allow proper

airﬂow.

NOTE: The reason for an elevated placement of the unit is that O3 is heavier

than air. Elevated placement allows for better circulation. It is also suggested

that the puriﬁer be placed in the room that is closest to the primary source

of odor.

INSTRUCTIONS / OPERATION