Use and Care Manual

7
USAGE
CONTROL PANEL FUNCTIONS
ON/OFF: Powers the unit on or o.
NOTE: This appliance will save your programmed settings even after
the power is turned o or is cut o. When powered on, the following
settings will resume: mode, humidity, backlight, and swing. Timer
settings will not be saved and will have to be reprogrammed.
MODE: Cycles between three (3) modes in the following order:
LOW: Low fan speed with low heat setting
HIGH: High fan speed with high heat setting
SLEEP: Low fan speed, low heat setting, and the LCD is dimmed.
(In this mode, the DIM setting will default to L2, however if L0 or L1
DIM setting have previously been selected, it will remain at that lower
level.)
HUMIDITY: Adjusts the desired humidity level. Press this button
once to activate the setting. Each subsequent press will cycle the
dehumidifier through the humidity options in the following order:
To select the humidity level, press the HUMIDITY button until the
desired percentage appears on the display. To return to the main
screen, wait about five (5) seconds. When set to continuous mode,
the unit will run regardless of current humidity and the continuous
icon will light up on the control panel.
If your desired humidity level has been reached, the unit will enter
“Auto Pause” mode. When in this mode, the unit will shut o and
the Auto Pause icon will light up on the control panel. The unit will
remain in this mode until the humidity rises by 5% or a new humidity
setting is selected.
NOTE: In continuous mode, the dehumidifier will run without
stopping regardless of the current humidity level in the room.
DIM: Adjusts the brightness of the display. Press this button to cycle
through the seven (7) brightness levels in the following order:
USAGE