User guide

3.2 Insert the SIM card and battery
SIM card
-Before using the telephone you need to insert a valid SIM card first. Any information and
messages related to establish a network connection and your calling initiation, along with the
names and phone numbers in your address book and messages are stored in the flat metal area.
To prevent damaging or losing information stored in the SIM card, you should avoid touching the
metal area, and keep it away from electrical and magnetic environments. Once the SIM card is
damaged, you can not access the GSM network.
Warning: Do remember to turn off the phone before taking out the SIM card. Taking out or
inserting the SIM card with external power connected is absolutely prohibited, as this damaged
the card.
-Switch off the phone, remove the back cover, after inserting the SIM card into its slot in the right
direction, card insertion is completed.
Battery
-To install the battery: Gently position the contact pins at the bottom of the battery into the
recess, then gently push the bottom of the battery into the position, place battery cover in place
and slide until it clicks into place.
-To remove the battery: Push the back cover down gently, then remove it, and gently take out the
battery from the bottom.
3.3 When using with 383
When use together with 383, the phone should turn the power off before push into the 383, then
put it into the back of 383, after that you can turn the 383,353 power on.
3.4 Charging the battery
If the device indicates a low charge, do the following:
3.4.1 Charging with 383
When the phone charging with 383, the battery power displayed in the idle screen will not
indicate charging status. Only the 383 shows the charging status.
3.4.2 Separate charge
1. Connect the charger to an appropriate electrical outlet.
2. Connect the charger to the device. The charger indicator light is lit when the battery is being
charged.
3. When the device indicates a full charge, disconnect the charger form the device, then from
the electrical outlet.
Tip: Disconnect the charger from the electrical outlet when the charger is not in use. A charger
that is connected to the outlet consumes power even when it is not connected to the device.
3.5 Headset
You can connect a compatible headset to your device. The mode of the device will switch to
earphone mode automatically. You can listen to music and answer /end calls via it.