User manual

8
3) Connect the other end of the charger to the power source.
4) When battery is full, switch of the power source, remove the charger from the power source and the
telephone
Note:
1) If the remaining power in the battery is too low to turn on the phone, charge the battery until full
before turning on again the phone.
2) Make sure that the standard voltage and power are correct for the battery charger.
3) During the charging/recharging period, you may turn on or off the phone, for better battery life it is
best to have the phone turned off.
4) For safety it is best to never use the phone whilst connected to a power source and during
charging.
4) Use the battery only for its intended purpose. Never use any charger or battery that is damaged or
not original.
5.4 Use of Battery
Battery Power Reminder
1) If the battery is not in used for a long time, the same must be fully charged before use.
2) The battery can be charged and discharged many times, but it has a limited life time. When the
conversation and standby times are noticeably shorter than usual, replace the battery.
3) The battery is rechargeable and optimal performance of a new battery is only obtained after several
complete charge and discharge cycles.
4) When a new battery is used for the first time or if the battery has not been used for a prolonged period, it is
necessary to connect disconnect and reconnect a second time the charger to commence the charging of the
battery.
5.5 Turn On or Off
1) Press the key for a few seconds until the display lights up and the phone turns on.
2) Press the key for a few seconds until the turn of screen displays and the phone turns off.
To set the time on the display
On turning on the phone for the first time, of after removal of the battery for approximately 15 minutes or
more, the time must be set.
1) Press up key
to enter setting manual
2) Press the up/down key until the correct hours displays. Press the key to confirm and the cursor
automatically moves onto the minutes.
3) Press the up/down key until the correct minute displays. Press the to confirm
4) The Phone automatically goes into standby.
5.6 Make a Call
After SIM card, battery have been installed correctly and time has been set and phone has been turned
on.
1) Press the number keys corresponding to the phone number to be dialed and then press the send
key. .
2) Press the End key to end the call.
5.7 Adjust Volume
During a call, you can press the Up and Down button on the left side to adjust the volume louder or quieter.
5.8 Answer a Call
When the phone rings to answer the call:
1) Press the Send key
2) To end the call, refuse and not answer a call, press the End key
5.9 Short-cut Numbers
To insert and save M1 or M2 or SOS number
1) In the standby screen, press the Up key to enter the setting menu screen
2) Press the Up or Down button to scroll options
3) Press the to select option
4) Insert number to be memorized to the button.
5) Press the to confirm.
Note: Whilst inputting the numbers: Press the end key to delete the number behind the cursor.
5.10 Phone book
To view phone book records. In standby screen, press down key or select from main menu
Dial from phonebook
1) Enter phonebook records
2) Press the up or down key to select phonebook records
3) Press the to select options
4) select dial option and Press the to call the number
New Entry a Phone Record
1) Enter phonebook records
2) Press the to select options