Operation Manual

Note: When installing the SIM card, make sure the

phone is turned off, and disconnected from other

devices such as charger, etc.

4.2 Install the Battery and Battery Cover:

1) Refer to “How to remove the battery cover” to take

out the battery cover.

2) Aim the metal side of the battery at the metal

contact area on the phone (where the battery

connector’s resilient slide), push the battery into

the battery seat.

3) Replace the battery cover, push it upward until

tight.

4.3 Charge/Recharge the Battery

1) Find the charger interface in the right side of the

phone.

2) Connect the charger with the charger interface; the

shape of the plug must be consistent with the

interface.

3) Connect the other end of the charger with the power

source.

4) After finishing charging, switch off the power, pull

out the plug.

5) You can use the power socket to charge. Place the

phone into the power socket, aim the metal plug,

use the line to connect the socket and the plug,

then connect the charger with the power source.

After finishing charging, switch off the power,

take out of the phone.